|
Re: Throw out bearing length?
Just to finish this thread. My old, tall bearing is a #CT1086H. Car quest cross referenced it to #1697-C. They are the same other than the bearing outer diameter is slightly smaller, but everything else is the same. I did not buy it because it cost $40, I am cheap and a new clutch, pressure plate and bearing cost ~ 100 at summit. When I replace it, it will be everything. Until then I live with a little rattle.
On another post it was said that the long bearings are for the multi fingered diaphragm clutch and the shorter one is for the bord beck style. This does not make sense to me being that most clutches that I have seen are diaphragm style and the parts stores are selling short styles?
I just wanted to include a few part numbers if it helped anyone in their own parts search.
__________________
67 K10, lwb, fleetside, 327, 4spd, 205, cab and 3/4 frame swap, 14 bolt, big window, and a "rustoleum roll job"
|