Quote:
Originally Posted by Matt_50
Earlier I tested the hazards. They work fine. Could I still have a bad ground?
|
When I did all my wiring I mocked everything up before hand and labeled all my wires with tape so when the final install happened I would just need to connect everything and wrap in loom.
Proceeded with the install and and got everything done & cleaned up and I had issues with my signals. I checked the ground and even tore everything out of the wire loom back to the fuse box thinking I must have split or maybe cut a wire.
Turns out one of the pins got pushed out in the GM 4 1/2" column connector. Once I fixed the pin and pushed it back together everything worked. Then I had to re-do all the loom and tape & mounting all over again.
So check your column connector. I didn't even clue in until that was the last spot and boy was I pissed after doing all that work. So take my advise
