The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

asphaltburner · 04-08-2010, 10:15 PM

Yo! raws67!
Thank you a million! That's JUST what I needed! NOW I have a reference to factory settings. No one on the engine forum would respond so, again, thanks!
Nothing about my 350 is anywhere near stock and I'm fine tuning my initial advance, centrifugal adv., and vacuum adv. at the moment. My final timing will be custom for the engine build, so factory timing is only a reference so that I know approximately what my initial timing is.
Thank you very much!
Thanks to you too Gary! My new harmonic balancer is FAR better than stock and has a full set of marks thru 30 degrees advanced, everyone should have one. But you can see that I don't even need a permanent factory mark, just a reference, 'cause my final setting will be custom.
Thanks, guys!
Todd.

04-08-2010, 10:15 PM	#8
asphaltburner Registered User Join Date: Jul 2008 Location: Ault, Colorado Posts: 862	Re: Pic of 350 V8 timing marks? Yo! raws67! Thank you a million! That's JUST what I needed! NOW I have a reference to factory settings. No one on the engine forum would respond so, again, thanks! Nothing about my 350 is anywhere near stock and I'm fine tuning my initial advance, centrifugal adv., and vacuum adv. at the moment. My final timing will be custom for the engine build, so factory timing is only a reference so that I know approximately what my initial timing is. Thank you very much! Thanks to you too Gary! My new harmonic balancer is FAR better than stock and has a full set of marks thru 30 degrees advanced, everyone should have one. But you can see that I don't even need a permanent factory mark, just a reference, 'cause my final setting will be custom. Thanks, guys! Todd. __________________ '78 3/4 ton 4x4 custom "Todd-built" FRANKENTRUCK! Last edited by asphaltburner; 04-08-2010 at 10:22 PM.