The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Dan in Pasadena** · 07-01-2011, 11:27 PM

Yeah, I did the "blow it apart" thing before and after agile I just felt a little overwhelmed and defeated.

On the steering wheel i used a Dremel tool to widen the cracks a bit - NOT any more than you need to get the goop deep into the cracks. I used JB Quik Weld but only because I had it. I'd recommend using regular JB Weld if you're gonna go buy it. Form with rat tail file then sand, sand, sand, did I mention sand?! I put about 5 coats cause of the trouble with the Rusto Pro bit you can get away with maybe 2-3
Posted via Mobile Device

07-01-2011, 11:27 PM	#102
Dan in Pasadena Senior Member Join Date: Nov 2008 Location: Glendora, CA Posts: 6,333	Re: Danny Boy is BAACK! w/ '55 Big Window Yeah, I did the "blow it apart" thing before and after agile I just felt a little overwhelmed and defeated. On the steering wheel i used a Dremel tool to widen the cracks a bit - NOT any more than you need to get the goop deep into the cracks. I used JB Quik Weld but only because I had it. I'd recommend using regular JB Weld if you're gonna go buy it. Form with rat tail file then sand, sand, sand, did I mention sand?! I put about 5 coats cause of the trouble with the Rusto Pro bit you can get away with maybe 2-3 Posted via Mobile Device