[ManNamedJed]

Long time between updates. My suburban doesn't fit in the garage, so I don't do much to it in the winter months.

This spring had lots of yard work, and my wife and kid actually got the Coronavirus (serious stuff folks, my wife was wiped out for two full weeks and is still not 100%). So no time for wrenching projects.

But finally get some stuff done. I replaced the oil in the trans and transfer case (it was fine, and new fluid did not cure my vibes).

I rebuilt the Edelbrock carb. My first one and it wasn't that hard. Followed a you tube video. While I was at it I installed the 'off road' spring kit from Edelbrock and put in a block on the rear fuel passage. Cuz its a 4x4 ya know.

I re routed the plug wires with some wire holders. Had to customize a bit since the rams horn come up higher than other manifolds. Not perfect, but will keep the wires off the exhaust.