[TBONE1964]

Hope this helps,

At the cluster connector #6 location, dk green wire, ohm from there to where it hooks to the sending unit on the engine. It is basially a straight shot through the harness. If it is open, then a repair or replacement of the wire is needed.

The only cluster feed from the ign is for power at the pink wire at #3 location on the cluster connector. This supplies voltage to the temp gauge as well as the fuel gauge and the power splits in the circuit board.

The wire should follow through the harness to the bulk head and then to the engine compartment. If you have key on and ground the green wire briefly, the temp gauge should peg.


Tom