The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

pancake · 04-26-2009, 10:14 PM

Sorry if this is a repeat post, The other one did not look like it was posted.

Almost ready to install but had a few more questions:

My Oil Pressure Switch has three wires coming off it: orng, gry, and light tan. I know where the orng and gry wires go but where does the light tan wire go?

To install Dizzy do I need to find TDC on #1 and install dizzy so rotor points at #1 plug wire?

What should I start with for timming for a TBI 5.7L?

I need to disconnect a wire to set timming? D5 lt brn/blk wire?

Any advice on timming or insatlling the Dizzy would be great.

Thanks again for all the help and I hope people are getting some usefull information from this thread!

04-26-2009, 10:14 PM	#166
pancake Registered User Join Date: Apr 2009 Location: Arvada, Colorado Posts: 84	Re: Tbi swap build thread Sorry if this is a repeat post, The other one did not look like it was posted. Almost ready to install but had a few more questions: My Oil Pressure Switch has three wires coming off it: orng, gry, and light tan. I know where the orng and gry wires go but where does the light tan wire go? To install Dizzy do I need to find TDC on #1 and install dizzy so rotor points at #1 plug wire? What should I start with for timming for a TBI 5.7L? I need to disconnect a wire to set timming? D5 lt brn/blk wire? Any advice on timming or insatlling the Dizzy would be great. Thanks again for all the help and I hope people are getting some usefull information from this thread! Last edited by pancake; 04-26-2009 at 10:14 PM.