The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

superhondaz50 · 02-13-2018, 12:48 AM

Ya, I had the raised pads towards the convertor. The center section is also raised, that raised portion also is towards the convertor, so the crank end sits in the dished side, but doesn't fit right, hence needing a shim.

02-13-2018, 12:48 AM	#9
superhondaz50 Registered User Join Date: Mar 2007 Location: Behind the Taco Bell dumpster Posts: 296	Re: New flexplate help Ya, I had the raised pads towards the convertor. The center section is also raised, that raised portion also is towards the convertor, so the crank end sits in the dished side, but doesn't fit right, hence needing a shim.