Some modifications required! I thought I had the down pipe all sorted, but nooo... it hung to low, and was aiming right at the new trans cross member. I wanted it up higher and to go over the top of the cross member which is how I designed that support from the beginning. So out came the down pipe, I removed all the wrap, then did a bunch more measurements, then the sawzall and I hacked it up into several pieces. Actually did some really nice cuts which only needed a slight clean up, and then tacked everything up and test fit it. Now I'm much happier with the fit and how everything is going to flow backwards.
I also got the rest of the battery cables finished up along with a new battery cut off (If I remember it I'll post a pic of that tomorrow, it's a really good one).
Stay tuned!