The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

DavidB · 09-18-2011, 10:51 AM

The axles are held in by c clips. Start by removing pin bolt then sliding out pin.

The in keeps the axles from sliding in so the c-clips don't fall out so after removing pin push axles in and remove c-clips.

Then slide both axles out.

09-18-2011, 10:51 AM	#4
DavidB Registered User Join Date: Jun 2007 Location: South Carolina Posts: 106	Re: 12 bolt rebuild + Eaton The axles are held in by c clips. Start by removing pin bolt then sliding out pin. The in keeps the axles from sliding in so the c-clips don't fall out so after removing pin push axles in and remove c-clips. Then slide both axles out. Last edited by augie; 02-16-2012 at 12:19 AM.