The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**pjmoreland** · 09-05-2021, 11:30 PM

The four large bolts in the ends of the cowl are 5/16-18 x 7/8 and are the same style that is used in many other places on the front clip, like for the inner fenders to the fenders. They have captured washers on them.

The smaller screws that pass through the cowl seal are the same style of screw that is used for fastening the glovebox liner to the dash. They are a Phillips head with a captured washer.

If I remember correctly, the four exposed screws that are up by the wipers are #10 pan head sheet metal screws that are approximately 1/2" long.

09-05-2021, 11:30 PM	#44
pjmoreland Senior Member Join Date: Jan 2005 Location: CA Posts: 5,294	Re: Hood to cowl seal and alignment The four large bolts in the ends of the cowl are 5/16-18 x 7/8 and are the same style that is used in many other places on the front clip, like for the inner fenders to the fenders. They have captured washers on them. The smaller screws that pass through the cowl seal are the same style of screw that is used for fastening the glovebox liner to the dash. They are a Phillips head with a captured washer. If I remember correctly, the four exposed screws that are up by the wipers are #10 pan head sheet metal screws that are approximately 1/2" long.