[makman1297]

Describing this may be a little confusing, so if i need to make a diagram i will. One terminal on the each relay will goto chassis ground to activate the relay. One will be a heavy 14g ground comming in that when the relay is activated will go throught the relay, one will be the heavy ground comming out and going to its respective brown/blue motor wire. The last terminal will be the power from the switch, the white stripe wire. Now is the complicated part, sort of. Each white stripe wire needs to be connected to each other, a jumper is necessary after cutting the terminals there two short. With this jumper you need to add two pigtails comming off of them, one smaller guage goes to te relay control, the other heavier 14g goes to the solid blue/brown along with the heavy ground comming off of your relay, of the same color. So blue/white to relay that the ground comes off of two the solid blue along with the jumper from the blue/white. This will give you your + and - on the motor. Now you do the same thing to the other side and now it will be - and + and drive your motor the other way. Clear as mud?