The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**robnolimit** · 03-02-2016, 07:37 PM

The new Panhard mount uses this hole to locate it. Chase it with the 3/8" drill bit and bolt the new bracket in place. There are two mounting rails for the panhard rod on the inside of the bracket. They should be at 90 degrees to the frame rail flats. Or, if the truck is level front to back, these mount rails should be straight up and down. Notice that the bracket fits the frame profile nicely when it is in it's proper location.

03-02-2016, 07:37 PM	#9
robnolimit Senior Member Join Date: Jul 2010 Location: Dandridge, Tn. USA Posts: 2,226	Re: No Limit Trailing Arm Rear Suspension The new Panhard mount uses this hole to locate it. Chase it with the 3/8" drill bit and bolt the new bracket in place. There are two mounting rails for the panhard rod on the inside of the bracket. They should be at 90 degrees to the frame rail flats. Or, if the truck is level front to back, these mount rails should be straight up and down. Notice that the bracket fits the frame profile nicely when it is in it's proper location. Attached Images __________________ GoodGuys 2012 Pro-Truck Champion 2012 Truckin' Throwdown Champion GoodGuys 2011 National Champion 2011 Truckin' Throwdown Champion GoodGuys 2010 National Champion Proud to put our products up against all others!