Re: Brake bleeding trouble... still
Hello, this thread has been helpful trouble shooting but I could use some advice. I’ve got a 1966 GMC with a brake pedal that goes to the floor- no resistance. New master cylinder, proportioning valve and front brake lines. Disc in front, drums in rear. I have bled the **** out of these brakes and I have no pedal. Must be a leak somewhere, but no visible signs. I pulled the back wheel off thinking maybe it’s a bad wheel cylinder (after reading these posts). I don’t see leakage on the cylinder, but the inside of the drum is soaked. The trouble is that I can’t tell if it’s grease or brake fluid that has attracted dirt over time. The brake shoes themselves look ok wear wise. Question is- do I bite the bullet and try replacing the cylinders, shoes and hardware?
Last edited by lsett; 11-20-2018 at 07:56 AM.
|