The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

fat56 · 12-15-2011, 08:37 AM

So its been a while since a update.

But alot of parts have finally turned up, accuair air management system, 60l polished fuel tank, billet steering column and steering wheel. So i have been busy.

couple of photos ..

Dash Before - if you look close enough you can see i left some bondo that was 5mm thick on the dash.

Dash all smooth

Mock up of some new parts

Air Management System

firewall before - someone had some real fun with a hammer making some room for the valve covers.

Almost Finished

Here are a couple of photos of the REALLY BAD install on the front clip. Not safe at all. As i said this truck was a woof is sheeps clothing.

Photo of my two mates trucks unfortunately both fords but still good cruisers

12-15-2011, 08:37 AM	#22
fat56 Registered User Join Date: Mar 2011 Location: Sydney AUS Posts: 160	Re: 56 chevy build (Aus) So its been a while since a update. But alot of parts have finally turned up, accuair air management system, 60l polished fuel tank, billet steering column and steering wheel. So i have been busy. couple of photos .. Dash Before - if you look close enough you can see i left some bondo that was 5mm thick on the dash. Dash all smooth Mock up of some new parts Air Management System firewall before - someone had some real fun with a hammer making some room for the valve covers. Almost Finished Here are a couple of photos of the REALLY BAD install on the front clip. Not safe at all. As i said this truck was a woof is sheeps clothing. Photo of my two mates trucks unfortunately both fords but still good cruisers Last edited by fat56; 12-15-2011 at 08:44 AM.