The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Marty68 · 03-31-2020, 12:50 PM

the coil is marked "12volt no need for resistance wire..."
I replaced the condenser. I am unable to satisfactorily (in my mind) see the points.
I had carb off I believe float is set correctly.
I will next rig a fuel pressure gauge up. I may not be getting enough fuel. under a normal cruise condition at 2400 rpm it is fine but under full throttle acceleration it is not....
maybe just for piece of mind change fuel filter

I AM mechanically inclined however I AN NOT a mechanic.

03-31-2020, 12:50 PM	#33
Marty68 Registered User Join Date: Nov 2014 Location: west coast, Wi Posts: 534	Re: Carb or ignition? the coil is marked "12volt no need for resistance wire..." I replaced the condenser. I am unable to satisfactorily (in my mind) see the points. I had carb off I believe float is set correctly. I will next rig a fuel pressure gauge up. I may not be getting enough fuel. under a normal cruise condition at 2400 rpm it is fine but under full throttle acceleration it is not.... maybe just for piece of mind change fuel filter I AM mechanically inclined however I AN NOT a mechanic.