The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

clinebarger · 08-07-2014, 10:58 PM

Reaction carrier is next, Soak the Reaction to Case Torrington Bearing it ATF for a few seconds, Put 2 small dabs of transgel where the Torrington sits on the Carrier, This will hold the bearing in place. Lube the case bushing will a light coat of Transjel.
Install the Carrier in the Case, Give it a good whirl, It should spin very freely in the case.

If the carrier is hard to turn, Take a Hammer, Grab it by the Head, Lightly hit the carrier with the Handle on the red circles in an alternating pattern, This will seat the Case Bushing.

08-07-2014, 10:58 PM	#59
clinebarger Senior Member Join Date: May 2009 Location: Fort Worth, TX Posts: 6,370	Re: 700R4 build thread. Reaction carrier is next, Soak the Reaction to Case Torrington Bearing it ATF for a few seconds, Put 2 small dabs of transgel where the Torrington sits on the Carrier, This will hold the bearing in place. Lube the case bushing will a light coat of Transjel. Install the Carrier in the Case, Give it a good whirl, It should spin very freely in the case. If the carrier is hard to turn, Take a Hammer, Grab it by the Head, Lightly hit the carrier with the Handle on the red circles in an alternating pattern, This will seat the Case Bushing.