I got a chance to work on the blazer a little today. I spent most of the day tearing out all of the rotten panels in the passenger side door area. I belive there was about 20 pounds of rust and dirt that came out of the truck today; and one rats nest.
I got the drivers side rocker box set into place, but my dad threw his back out so we were unable to weld it in today.
It felt so comforting to complete the metal work on the drivers side door and rocker area. Then it felt very deflating to start it all over again on the passenger side. Here is a shot of the passenger side before starting. It was much better than the drivers side when I started on it.
After taking off the rotten rocker panel I was left with the typical rotted out lower door pillar.
At least on this side I was left with enough metal to take pictures for references.