The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Rewired 70 C10 heater and running lights on even if ign is not plugged in.

C10Coloradoguy · 08-27-2017, 08:48 PM

Thanks VV,

Well, a major part of my problem is that my rear lights were not properly grounded. I have running lights all the way around, brake lights and I'm 99.9% sure my reverse lights work. I have installed a new turn signal switch but now when I push the lever left or right, no turn signals. I switched the flashers in the block and got the same result. What I did not do is push the lever one way or another and leave it there which I tried when the fuse was blowing. Now that the rear lights are grounded, I am just pushing the lever left or right, counting to 1, and putting it back to "neutral". The good news is that no fuse is popping. The bad news is that my signals aren't signalling.

I will also run your tests above. Hopefully I didn't blow something on this new switch...

08-27-2017, 08:48 PM	#27
C10Coloradoguy Registered User Join Date: Jul 2017 Location: Highlands Ranch, CO Posts: 39	Thanks again VV! Thanks VV, Well, a major part of my problem is that my rear lights were not properly grounded. I have running lights all the way around, brake lights and I'm 99.9% sure my reverse lights work. I have installed a new turn signal switch but now when I push the lever left or right, no turn signals. I switched the flashers in the block and got the same result. What I did not do is push the lever one way or another and leave it there which I tried when the fuse was blowing. Now that the rear lights are grounded, I am just pushing the lever left or right, counting to 1, and putting it back to "neutral". The good news is that no fuse is popping. The bad news is that my signals aren't signalling. I will also run your tests above. Hopefully I didn't blow something on this new switch...