The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

toddtheodd · 04-09-2006, 09:57 AM

I've got a brass pin that I use when hammering on anything on my truck. It came out of a U-joint for a big rig. Since the brass is softer than steel, I don't have to worry about damaging the steel.
Ft. Worth Gear and Axle have them, and most likely other places that work on big drive shafts will have them as well.
Toad

04-09-2006, 09:57 AM	#19
toddtheodd The oddest Todd around Join Date: May 2004 Location: Miami, Florida Posts: 1,418	Re: Any tips for spring removal? I've got a brass pin that I use when hammering on anything on my truck. It came out of a U-joint for a big rig. Since the brass is softer than steel, I don't have to worry about damaging the steel. Ft. Worth Gear and Axle have them, and most likely other places that work on big drive shafts will have them as well. Toad __________________ "The greatest pleasure is to vanquish your enemies and chase them before you, to rob them of their wealth and see those dear to them bathed in tears, to ride their horses and clasp to your bosom their wives and daughters." Ghengis Khan IIOY???