Re: Rearend issues
I had the same problem with a g80 . Got the bolt out and still would not come out . Turns out the spider gear welded itself to the pin . If you inserted a new locking pin all the way in there is no reason the center pin should not come out if no other problem exists . This means the locking pin went all the way past the pin on both sides and should be clear to come out . If not you could have the same problem I had . I hammed on it pretty hard and would not budge . I wound up taking an angle grinder and cutting it in half on both sides to set it out . Even then after cutting the spider gear in half it would not come off the shaft it was welded so hard to it .
|