The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**VetteVet** · 11-29-2005, 12:09 AM

I will check it out when I open the case. It stops at just below zero and on the high end where it should but it may be slipping on the inside like you say. I know it's a variable resister that controls the motor so it may be something simple like that. The machine is like new and I haven't used it that much so I was surprised to see it mess up. I will look at it and let you know what I find.
Thanks for the tip.

11-29-2005, 12:09 AM	#31
VetteVet Msgt USAF Ret Join Date: Jan 2005 Location: Kalamazoo, Michigan Posts: 8,705	Re: Welders! I will check it out when I open the case. It stops at just below zero and on the high end where it should but it may be slipping on the inside like you say. I know it's a variable resister that controls the motor so it may be something simple like that. The machine is like new and I haven't used it that much so I was surprised to see it mess up. I will look at it and let you know what I find. Thanks for the tip. __________________ VetteVet metallic green 67 stepside 74 corvette convertible 1965 Harley sportster 1995 Harley wide glide Growing old is hell, but it beats the alternative.