[62gmc910]

Originally Posted by 62 Bowtie

great idea 62gmc I've got one or two rather for ya. I installed a 73 automatic column and a ez-wiring kit on my 62 I have no connector for the turn sigs and I'm wondering if I can make my own 8 pin connector it's just male and female right? My other issue is my accy is not wired correctly, when i hook it up all accys work but when I start the truck the starter makes a noise like the bendix is stuck then when I turn it off the engine stays running and no response from the ign sw untill I disconnect the accy wire from the ign sw unfortunately the diag from ez wiring sucks

I would find the connector from a 73 that plugs into your column and I can't
remember what type of ends they have right now but there are a lot of replacement ends on the market that way if you have to change the column or the signal switch it just plugs in.
I'm not familiar with ez but it sounds like alternator feed back or the power wire going in to the wrong terminal on the ign. Are you using the 62 switch or the 73?