[steve aleve]

I have recently fabricated a roll pan for my 54 3100 to incorporate the exhaust tips into the look of the truck. I have an LS engine with a corvette upper end in the truck with C6 exhaust and I kind of wanted to hint at what is under the hood. I just finished fabricating mine but when I installed it it looks like it sits low and is too narrow. Any thoughts or ideas? I have photoshopped my taillights a bit lower and tucked to conceal the narrow ends of the roll pan but still not sure about it. I haven't pulled it out to get any better pictures than these. Any ideas would be appreciated.