[1956cameo]

Thanks for the compliment lks dcvn! The inner panel went on almost too easily, yet the outer panel wanted to settle in high and a little forward. What we ended up doing was tach welding the top in and then using a rubber hammer and a body hammer to massage the panel into the right position. The only part that didn't go in exactly like it came out was the very bottom rear corner, it ended up bieng about 3/8 of an inch high and about the same forward.

I wish I lived closer to other blazer addicts as well! I would definately help you with your project if I did. Hopefully the weather will cooperate for you so you can make some more progress.