Quote:
Originally Posted by ezz16
just installed a 350 and Muncie 4spd in a 66 lwb c10 and will need a driveshaft it will need to be 72 inches from rear u joint to the rear trans seal I measured it where the seal runs on the yoke.i can have it shortened does anyone know what vehicle I need to look for?
|
Just another option to consider and this may not be any help. The shop you are going to use to cut and balance the shaft, have you checked with them about making a shaft the right length using your end caps? It might be similar in price....or I might just be spoiled by having a full service driveline shop a short distance away.