Re: Looking for advice - wood bed 63 C20
Quote:
Originally Posted by jayoldschool
Like I said, first set was on radial arm saw (turned sideways) second was table saw. Need a dado blade for the second cut.
That wood looks rough, it looks like it needs a pass through the planer...
|
I do not have access to any of those. I do have a router and can easily cut the 3/16 groove. Just not sure what router bit to use to get that 1/8” cut off the edge.
These rabbeting router bits use a different size bearing to make a different cut?
EDIT: I’m doing everything from the rear bumper of the truck, so not a lot of options.
I think I’ll just get a 1/2” router bit and router the last edge, just a little less deep.
__________________
1963 C20, small window, long bed
292, 4-speed
Last edited by Asshat; 07-18-2020 at 11:00 PM.
|