[99 to Life]

This is when I was running 3" blocks and 2" drop spindles. Leafs and rear were off a 4x4 s10. I mounted body about 3.5" off frame I think, running boards are about 5.5" off ground. Iv hit so many crazy pot holes and drive in PA weather/roads and I would say this is about the lowest I'd wanna go with a static drop. Bags, I go 4" off ground! I run 14" rims and a total of 26" tall tire.

P.S did you cut about 5" off back of frame? I weld angle on the outsides of frame and let the rear bed mounts set on those, super easy to make bed mounts. You want to set your cab height like stated, but that also will dictate the wheel centering. always mount cab first, then got to front clip, then to bed and never final weld till you get it spot on, squared and level. take a look at all angles cause sometimes the front will look funny at a certain angle, esp if mounted too high.