The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**8man** · 05-12-2018, 09:24 AM

I checked the 3 corners for misses and got them welded up yesterday.

I had some blow outs on the "old" sheet metal. It seems that at the edge it would occasionally blow out. When it did, if I put a weld dot just off the edge, when I went back to the edge it seemed to hold.

Is this the way you would do it?

I will post pics later this weekend, right now I need to get back on the 4th corner.

05-12-2018, 09:24 AM	#59
8man Senior Member Join Date: Sep 2017 Location: Bryan, Texas Posts: 2,279	Re: Wife's 48 I checked the 3 corners for misses and got them welded up yesterday. I had some blow outs on the "old" sheet metal. It seems that at the edge it would occasionally blow out. When it did, if I put a weld dot just off the edge, when I went back to the edge it seemed to hold. Is this the way you would do it? I will post pics later this weekend, right now I need to get back on the 4th corner.