[MTCK]

It seems like forever since I did any real work on this project, but I finally picked up all my parts from the machine shop today. I have been accumulating parts this whole time, and I'm pretty excited to start wrenching.

The machine shop boiled and magnafluxed everything, honed the bores, surfaced the heads, valve job, polished the crank and checked everything out. Heads were reassembled with comp cams springs, locks, keepers and rotator eliminators. Freeze plugs and galley plugs installed along with new valve guide seals.

I procured a new timing set, cam, adjustable rocker studs and nuts, main and rod bearings, rings, a distributor (billet aluminum body) EGR block off plate and plug, block heater and of course gasket sets. Time to get wrenching!