Re: My Big Fat Renovation
Back in order...
1. I got the walls painted and started cutting and fitting the lower trim pieces.
2. The pain in the ass nook area finally painted.
3. The pump came in and it had been a week and we need the machines back, so back in they came. Note how much higher the dryer is...
4. Sigh... I cut the angles wrong on my crown molding... that was an expensive oops. Rather than mess up my fresh walls and ceilings I used a screwdriver to dig around the nails and then pulled them out with a pair of vice grips, no wall damage, but destroyed the trim. Oh well. I watched a couple online videos on how to cut the molding, and set up my saw properly to be able to do so.
5. Now THIS is how the corners SHOULD look!!!
Last edited by 67ChevyRedneck; 02-06-2010 at 03:11 AM.
|