Driver side cab corner - Continued
So here is where I ended up finishing for the night. I grabbed the other piece and realized that it was going to be really hard to mimic the bottom edge around the corner so I cut it at an angle and welded it to the left corner piece. This way the strip I need to build will be easier and uniform. You can see in the last couple pics how short the cab corner ended up being and you can see how the angle will help be build a new piece to weld in to bring it all together.
Lastly, check out how flush this one is !!!! BOOM!!
I should be able to finish this up tomorrow. Then I will be ready to pull the cab back off again to spray primer, bed liner, then lizard skin ceramic coating to the bottom of cab. Then it goes back on the frame for good!!