Quote:
Originally Posted by Hogshooter
I like the wire wheel and a 3M clean and strip disc to clean those tight spots followed by epoxy primer rather than the weld through primer, it is catalyzed and has better corrosion resistance properties, like the rust encapsulator. If I were you I would not spray the underside until you have welded the part in to save material. Great job so far on the skill development the lessons you have learned will serve you well installing the floor.
|
Thanks for the tips. I am a little confused. If I use Epoxy primer, will I still be able to weld that area? I want to use epoxy primer on the rest of the cab, but I did not think I would use it on the weld area.
Also, it seems easier to use the encapsulator while the floor is off the cab. I am not going to spray the areas that will be welded. How will I be wasting material? The undercoating will wait until the cab is done.
Thanks for the compliment. I have learned a lot so far, and getting tips and advice from other board members has been invaluable.