Re: 86 chevy crew cab 12 valve swap
White lithium, grease and some persuasion.
witht he truck sitting on level ground, put an angle finder on the kingpin cap. across the heads of two bolts is usually good enough if they are the same. then compare that to the angle reading of the the frame rail in a place where it is flat. it should be tipped back at the top 3-6 degrees.
the alignment shop will only be able to set toe. the other angles are hard set. if you need to adjust the caster a shim will work, but i doubt the shop will do that.
__________________
72 K20 12v build
72 K20 "parts truck"
|