Re: vent window woes
The next two pics show the mid section of both pieces of gasket. #9 is the area where the gasket meets the pivot rivet bracket. Obviously, one has a cutout and one doesn't. If you read the previous posts, you'll recall I had concerns about the PRP gaskets and having to cut that section out. Not a big deal, but just the unknown necessary procedures are what make the process frustrating.
#10 shows the holes for the rivets to mount the vertical portion of the gasket. You can see the CPs have a counter bore molded into the rubber. This is better because it give the rivets a more positive stopping point and they don't squeeze out the rubber from underneath.
CPs are on the right in both pics.
|