Quote:
Originally Posted by dmjlambert
Part 4
Re-assemble the bulkhead connector and screw it into place.
Test to make sure with the key in the on position the wire gives 12V.
Route the wire neatly along the firewall plastic wiring gutter and plug in to the HEI distributor.
That's it.
|
Funny story about this change. My blazer already had an hei on it. The PO ran a wire from the fuse box, through the firewall and to the hei. I removed that and then ran the wire just like you did. The funny part was those two yellow wires that go to the starter and the coil were just left dangline, LIVE!!! I had no idea what that wire was for until i just saw this picture.
Nice writeup.