Re: 1971-72 C10 Cable Throttle Install
Made some progress on mine today. Like I said the pedal assembly is out of an 83 c10. I cut off all the excess that the OP cut. I then trimmed the plastic up to make it narrower and I cut the raised portion of the right side rear, so it sits flat against the slightly angled fire wall.
My pedal seems a bit different than both of the others, but it'll work as well. At this point the only question I have that I need to figure out is do I bend the upper portion of the rod to the left or if I try to twist the flat part where the cable attaches to the arm so it can exit the angled part of fire wall straight on.
It seems to me that if I go through the angled portion it would be straighter shot to carb. Problem is I don't have the engine/carb I'll be using in the vehicle yet do i might hold off on creating this hole.
Thanks for all of the help, especially Chris!
|