[Problems]

So tonight I made the room for the trans and drive shaft. You can see how high the trans needs to be in order to match the pinion angle. I thought it would take a few hours it took 8. Guess I’m not very fast at fabrication. I cut the back off my high hump, and sectioned a low hum I had laying around to make an extra long high hump. Then I cut the floor out behind the hump and raised that too.

When my wife wakes up in the morning I can finally measure for a drive shaft. Next is taking 2” out of the front of the bedsides I can’t wait to see how long that takes me.