[beaterku]

Forward progress. Started working on the panhard bar cross member. Ran in to a problem that I knew I was going to have. The girdle cover I have sticks out to far. To get the panhard bar to clear the cover, I have to move the cross member back 3.25". This is not going to work with the Boyd tank I have so I am going to have to ditch the girdle cover for now. I may, down the road, fabricockle a new panhard bar that clears the girdle cover, but for now, I am going to use the stock cover and locate the crossmember were it is supposed to be.

The front edge of the blue tape is where the center of the cross member is supposed to be. I installed the shocks to see where the axle will hang at it's lowest, which also happens to be the worst case scenario. It's a bummer, but I'll make it work at a later date.