Quote:
Originally Posted by RockTonka
Thanks CW!
We pulled the rear sway bar off...the mounts on top of the axle were hitting the frame as we played around with spring rates on the coil overs.
We will run a bit with just the coil overs to see if they can compensate much for body roll...we have adjusted the rebound/compression a bit with positive results though.
|
That would be a good reason to pull it off
I just went back to where y'all installed it (page 12 for anyone else wondering) to see how y'all had mounted it. I want to add a bar to my truck as well, so I've been gathering up ideas. Still have stock stuff under mine, so no worries about hitting anything yet.
Sounds like the coil overs are the way to go, but for now, stock is just fine
__________________
Christian Carpenter
1963 C10 -
Frankentruck 283, 3 speed with overdrive
Overdrive wiring here
1963-ish truck bed trailer -
Half-Wit
1981 C10 -
Penny 305, th350
1995 Dodge Dakota Sport
"I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson