Re: Mounts not lining up.
Thanks for the input. I think the transdapt plates are the same design as the moroso. I spent a few hours playing around with engine positioning last night, swapped towers from side to side and whatnot seeing if there was going to be a simple solution. I decided I want to raise the engine about an inch and a half and set it back about an inch from the forward position. I am going to modify the top half of the towers while I am away at work and then finish the bottom half with the engine mocked up as modifying the whole thing will be difficult with nothing to test fit. I think there is a slim chance I'll be able to run the manifolds with some slight notching of the frame but I am going to get the engine in first and go from there.
Posted via Mobile Device
|