View Single Post
Old 03-10-2015, 01:55 PM   #7
cooperhw
Registered User
 
cooperhw's Avatar
 
Join Date: Oct 2014
Location: Mesa AZ (Near Phoenix)
Posts: 2,292
Re: LS Steam tube routing

I drilled an 1/8" pipe size hole right in the top of the water pump below the hose. Then tapped it to accept a brass fitting that was 1/8" male pipe thread on one side and barbed end on the other (got it at Ace hardware). Then you take the line coming out of the drivers side head and attach it to the barb. Simple.
I have a late model (new) radiator that has a port for this hose and still did this as it cleans it up a bit.
Oh yeah, it's in a 67 Chevelle if that matters.
__________________
"Life is too short to drive a boring vehicle".
Later,
Wayne
cooperhw is offline   Reply With Quote