The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Peanut74 · 05-16-2019, 09:21 AM

Thanks for the info everyone. I am at the edge of the cliff and when I take the plunge I want to make sure I hit water and not the rocks.

After reading everyone's input I am going to make sure the stand and cab are level with the floor. I have the cab mounted to my fixture at the cab mounts so I'm good on that front. Just need to shim where required to get it level.

As for the bracing if I run it to the inside of the cab I should be able to mount the doors to check gaps. Not quite as solid as running the brace in between the pillars but I believe it should work and still allow me to mount the doors to check gaps. What does everyone think about that plan?

05-16-2019, 09:21 AM	#8
Peanut74 Registered User Join Date: May 2018 Location: Prattville, AL Posts: 590	Re: Order of rust repair Thanks for the info everyone. I am at the edge of the cliff and when I take the plunge I want to make sure I hit water and not the rocks. After reading everyone's input I am going to make sure the stand and cab are level with the floor. I have the cab mounted to my fixture at the cab mounts so I'm good on that front. Just need to shim where required to get it level. As for the bracing if I run it to the inside of the cab I should be able to mount the doors to check gaps. Not quite as solid as running the brace in between the pillars but I believe it should work and still allow me to mount the doors to check gaps. What does everyone think about that plan?