[mountie]

If you just do it, ...it's easier than you think....
Refer to top 1st post for pictures..........
*Un plug the harness.
*To remove the wiper delay box, just 1 screw (torx) at bottom of delay box
*Wiggle box..... it pulls out easy.
*There's 5 slip-contacts. (You'll see what I mean)
*With the box in your hand, use a putty knife or flat scewdriver and dislodge the 3 plastic 'holders' and wiggle off the front cover ( you see the contacts for the harness)
** You will see the delay circuit board.
* Slide the board out ( there are channels on each side for board to slide)
*I saw 1 cracked solder.
* use a small brass wire brush & clean the contacts

Well,..... at least the wiper turns on, but still no delay.

I sure wish I could buy just the board. It is so easy to replace....