Re: Fuel filler options
Thanks for the replies.
Quote:
Originally Posted by HuggerCST
Mine has a spring attached to the side of the leans backing plate. That spring is mounted at an angle so that it cams over and holds it open, or closed. I simply push on the bottom of the lens to open it.
|
That is a slick idea, I would have never thought of it.
Quote:
Originally Posted by tinkerdad
Mine has a magnetic cabinet latch in the upper right hand corner. When you push on the top it pops out. You can then pull it down.
|
This is what came to my mind when I was trying to figure it out, seems like it would work well.
__________________
68 3/4 ton (Project)-350 Small Block, .030 over, 10:1 comp, 3998993 heads, C3BX edelbrock intake, comp cams XE268, Holley 670 SA, long tube headers, dual flow 40's, E-fan, Alum rad, currently under the knife getting shortened and bagged build thread
41 3/4 ton (wife's)-flatbed, fully restored to original
01 Tahoe LT 4WD (my daily driver)-Magnaflow Muffler, Rollin on 22's
02 Ford Mustang Convertable (Wife's Car)-Flowmaster 50, Clear corners, Intake, sittin on 18's
|