View Single Post
Old 01-13-2008, 08:41 PM   #18
mcc-bri
Registered User
 
mcc-bri's Avatar
 
Join Date: May 2007
Location: Winnipeg, Manitoba
Posts: 188
Re: 67 gmc-project ball to the walls

well i started on fixing one of my drip rails. I cut out the really bad spot and am putting in a new peice. i had to clean up underneath the drip rail, i metal preped it and sprayed it with this special primer that you can weld on. i have already started welding the peice i made in but its not done and i wont post a pic till it is. My dash is done other then finishing the edge on it were the ignition is. Can someone tell me how to get that ignition out of the dash?
Attached Images
     
mcc-bri is offline   Reply With Quote