|
Re: Lifting a 2wd
If you really want spindles:
Originally Posted by suicide 63
The recipe is
73-87
upper control arms any <c10-c20-c30>
lower control arms c20-c30
88-98
spindles for 1-1/4 inch rotors any exended cab will have them
rotors or a light dudy 3/4 ton they were six lug
upper and lower ball joints
outer tie rod ends
brake hoses
calipers
What makes this work is the 88 up ball joint presses into the 73 up 3/4 ton lower a-arm
Yuo will have to cut about a 1/4 inch off the new tie rod ends to get proper alignment.
Dont forget abought 88-91 square body stuff it all interchanges.
good luck
classic performance products has six lug rotors that go on 73-87 1 1/4 inch spindles about $120 for a pair.
Use this with a pair of lift spindles from Fabtech and 4" rear springs
__________________
1966 C30, Cummins, stacks, and a flat bed in progress...
"Honor.....simply put,
A veteran - whether active duty, retired, national guard or reserve is someone who, at one time in his life, wrote a blank check made payable to 'The United States of America', for an amount of 'up to and including his life.' That is Honor, and there are way too many people in this country who no longer understand it."
-AEC Hundley USNR
|