The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Ghost's68 · 09-22-2016, 06:32 PM

Not much of an update. It I did get some progress done. I was battling a damaged front cross members rivets, so I just decided to hack it up and install a undamaged one I picked up from a great member here. Thanks Randy! You can see the nice dent in the middle there. Took a flap wheel where I was doing some hammering to just clean up the area. Ready to throw the new one in and get the ECE sway bar installed.

Little buggers giving me problems

And I got my legacy plates after a 3 month wait!

09-22-2016, 06:32 PM	#15
Ghost's68 Registered User Join Date: Jun 2016 Location: American Canyon, CA Posts: 253	Re: And so it begins! Ghost's 68 project Not much of an update. It I did get some progress done. I was battling a damaged front cross members rivets, so I just decided to hack it up and install a undamaged one I picked up from a great member here. Thanks Randy! You can see the nice dent in the middle there. Took a flap wheel where I was doing some hammering to just clean up the area. Ready to throw the new one in and get the ECE sway bar installed. Little buggers giving me problems And I got my legacy plates after a 3 month wait!