[clinebarger]

Remove Pump Seal, Drive Pump Bushing out from the seal side of the Pump Cover.

Flip the Cover over, Install Pump Bushing from the Pump Pocket side, Coat the outside of the Bushing with Loctite before installation, Install Front Pump Seal, Use Loctite on the outside of the Seal.

Install the pivot pin spring (204) into hole.
Install the O-ring seal (202) and oil seal steel ring (201) into the groove on the back side of the pump slide (203).
Use TransJel to retain the seal and the ring on the slide.
Using TransJel, Install the pump slide seal support (208) and the pump slide wiper seal (209) on the slide.
Install the pump slide (203). **The oil seal ring must face downward into the pump pocket.**
Index the slide pivot notch with the pivot pin notch.
Work the pivot pin (205) between the Slide & Pump.

Install Inner & Outer Primer Springs, Some people use screwdrivers, I Compress the spring in the end of a Vise (with half the diameter sticking out) & knock the spring in with a Hammer Handle while holding the Pump Cover over the exposed part of the spring, Hold the Slide to the Cover while doing this.