[clinebarger]

Pump continued....

Locate TCC Apply Valve train (Outlined in Diagram), Remove Snap Ring, Remove Valve Stop, Apply Valve & Springs, Reinsert valve into bore, Check for side play, If present....Install Sonnax 77805-K Valve, The Teflon seal will prevent Cross-Leaks.
If no wear is found, Clean & reinstall Valve train.

Enlarge the hole circled, This will match the drain back hole in the pump cover & help prevent Seal Blow-out as the pump bushing wears.

Stator Shaft Sealing Rings (233 in the diagram), If you have 1 piece Teflon Rings, Check for nicks or damage, If none is found reuse them, If you have Scarf Cut sealing rings, Replace with new Scarf Cut seals.

**Note/Tip, The Teflon 1 piece Stator Sealing Rings Grow when not installed the Trans, Use your old Revere Input Drum to keep them sized until pump install**